2018 TANA Shark 440DTeco slow speed shredder with 4,200 hours. Over $100,000 in new components installed by dealer 200 hours ago. Brand new rotor shaft, knives haven't even been flipped yet.
Purchased in September 2023 with 4000 hours from Humdinger Equipment.
Humdinger's Build List:
• New Heavy Duty Door
• New Front Hood
• New Modem
• New Magnet Cover
• Rebuild upper Hopper
• Install New rollers and bearings on conveyor
• Repaint Additional warranty-covered replacements (post-purchase):
• Charge pressure pump
• Both track valve blocks ($11k each)
• Pressure switches
• Relief valves on both rotor motors Tane at sensor/exhaust temp sensor
• Magnet on/off flow valve
• Thermostat block pressure valve 2 Current Condition:
• 200 Hours on machine since purchase
• 150 hours run time (50 hours testing etc.)
• The machine has been idle since July 2024 after completing a 1200-ton tire job. Suggested Before Full-Time Commissioning:
• New conveyor belt (approx. $7k)
• Remote service/internal repair (approx. $5k - works without Remote)
• Magnet roller replacement (approx. $3k) ADDITIONAL VALUE:
• Rotor Knives: One fresh side remaining, plus an entire new set included.
• Counter Knives: Can be rebuilt and still have a fresh side.
Weight 70,327 lb
Length 33 ft
Height 12 ft
Width 8.5 ft